Search

Photosensitive Resistor Sensor Module for ArduinoFeatures-The photosensitive device, its photocurrent increases with the applied voltage.the temperature coefficient. Photoelectric effect photoresistor influenced by temperature, partial photoresistor optoelectronic at low temperaturesHigher sensitivi..

A3144 Hall Effect Sensor ModuleFeatures-Digital Output Hall-effect sensor.Operating voltage: typically 5V.Output Current: 25mA.It can be used to detect both the poles of a magnet.The output voltage is equal to the operating voltage.Operating temperature: -40°C to 85°C.Turn on and Turn off time is 2 ..

Flame Sensor infrared Receiver Ignition source detection moduleFeatures-Indicator light: a green one for the switch, a red one for power.Built-in a potentiometer for sensitivity control.Onboard signal output indication, output effective signal is high, at the same time the indicator light up, the ou..

Flame Sensor ModuleFeatures-High Photo SensitivityFast Response TimeSensitivity adjustableDetects a flame or a light source of a wavelength in the range of 760nm-1100 nm.Detection range: up to 100 cm.Adjustable detection range.The detection angle about 60 degrees, it is sensitive to the flame spectr..

LM393 Photosensitive Light-Dependent Control Sensor LDR ModuleFeatures-It comes with Mounting Hole Screw.Easy to installSignal output indicator light.LDR module 4 PINAble to detect ambient brightness and light intensity Adjustable sensitivity (via blue digital potentiometer adjustment)Output: DO dig..

BMP180 Digital Barometric Pressure Sensor ModuleFeatures-Can measure temperature and altitude.Pressure range: 300 to 1100hPaHigh relative accuracy of ±0.12hPaCan work on low voltages3.4Mhz I2C interface..

Normally open vibration sensor moduleFeatures-Using the company’s high-sensitivity vibration switch, the default with SW-18015P vibration sensor.The comparator output, the signal clean, good waveform, driving ability, more than 15mAWith a fixed bolt hole, easy to install.The use of wide voltage LM39..

Infrared Obstacle Avoidance IR Sensor ModuleEasy to assemble and useOnboard detection indicationThe effective distance range of 2cm to 80cmA preset knob to fine-tune distance rangeIf there is an obstacle, the indicator lights on the circuit board...

BMP280 Barometric Pressure and Altitude Sensor I2C/SPI ModuleFeatures-Libraries and tutorials available for Arduino and other microcontrollersOperating Voltage: 1.71V to 3.6V – would typically be operated from 3.3VOperating Temperature: -40 to +85 deg. Celsius (full accuracy between 0 and +65 deg. C..

Magic Cup Tilt Switch ModuleFeatures-    Magic Light Cup Module is a board which has a led and a mercury tilt switch. Using PWM to drive the LEDs on the module you can achieve the effect of light being “magically” transferred from one module to the other when tilting them. In sho..